"We Serve Quality"
  • 9644900063,7566355555
  • info@amanbuilditect.com
  • 230 B, Trade Centre, South Tukoganj, Indore
"We Serve Quality"
  • 9644900063,7566355555
  • info@amanbuilditect.com
  • 230 B, Trade Centre, South Tukoganj, Indore

Product Range

Gypsum Plaster


BuildWell Gypsum Plaster is a light weight gypsum based plaster suitable for application on most internal surfaces including brick, block and concrete. It consists of superior quality gypsum, formulated with special additives to enhance working and setting characteristics, also improves workability and coverage. When dry, it provides superior whiteness, smooth and matt finish and is suitable for all internal dry plastering applications.


  Superior whiteness.

  Affordable & Cost effective.

  Free from shrinkage cracks.

  Provides excellent bonding.

  Light in weight.

  Imparts high coverage.

  Zero maintenance.


Not Applicable


  Faster setting than the conventional sand cement plaster

  Reduce structural load on building as it is 50% lighter then sand – cement plaster

  Direct application on RCC, sand cement plaster surface & surfaces to be repainted

  Smooth matt uniform surface finish

  No water curing required

  Compatible with all types of paints & decorative range

  Low consumption of paint


Remove all the loose adhering particles from the surface by using wire brush and potable water. Pre - wet the surface before application to achieve good work ability and higher coverage.

Mix powder to water and not water to powder. Water to plaster ratio is (1 part water and 1.5 part of BuildWell gypsum plaster (GYP+) to be maintained to provide good cohesive workable mix. Mix BuildWell gypsum plaster (GYP+) to water by using electrical hand mixture rod to form uniform lump free paste, install the wooden strip / dhada or install the leveling strip in the area where the ready paste is to be applied. Apply the first coat approx. upto 8 mm to 10 mm of thickness, before the first coat sets rake and cross rake the surface. Fill in any hollow area, Level off and compact the surface, then apply the final finish coat. After complete drying for usually 72 hrs. (Depending on the thickness and humidity), the plain smooth leveled surface is ready for painting application.

Once the mix has begun to set, additional dry material should not be added, as performance properties of plaster will get altered, thus affecting work ability, cohesiveness, adhesion and strength. A single coat should not exceed more than 8 mm to 10 mm of thickness. If at all thickness required is more than 8 mm to 10 mm, then plaster is to be applied in multiple coats. Use the material instantly after mixing. The surface on which the material needs to be applied should be in line and levelled. BuildWell Gypsum plaster (GYP +) should not be applied on surface which is subjected continuous seepage or dampness.

Wear eye protection, impervious gloves and protective clothing. Advised to avoid direct eye and skin contact and recommended to keep it out of reach of children.

BuildWell GYP + (Super white gypsum plaster) is available in 25 kg Bag and has a shelf life of 6 Months from the date of manufacturing if stored in a cool and dry location. (As temperature, humidity, water addition and other parameters vary from site to site; the above information should be treated as a general guideline)



Technical specifications

Application Superior Whiteness
Pot life 25 – 30 minutes
Initial Setting Time 15 – 20 minutes
Coverage @ thickness of 10 mm. 20 – 25 Sq. ft./Bag of 25 Kg


Not Applicable.